Page To Fit The Seat To The Chassis Minivator series Installation Manual To fit the seat to the chassis Place the seat chassis top moulding on the chassis, and feed the harness and seat stem and seat assembly through the holes in the moulding and chassis Fig. To Infra-Red unit Fig. Page Program The Stairlift And Handset Minivator series Installation Manual Program the stairlift and handset Rotate the seat through 90 to gain access to the main control board as shown in Fig.
Page To Change The Hand Required For Control Minivator series Installation Manual To change the hand required for control The chair is factory supplied for the user to use their right hand for controlling the chair. To change the control position: Carefully unplug all armrest wire sockets Page Connect The Track Loom To The Transformer, And Test At Final Installation Minivator series Installation Manual Connect the track loom to the Power Supply and test at final installation Note: The Minivator series stairlift is battery operated from the 33V output power supply, and can therefore be safely connected to the household Power supply mains supply via the normal ring main.
Page Fit The Hand Control Holder Minivator series Installation Manual Fit the track top plastic finishing extrusion, sliding under the power unit, and snapping it into place, Fig.
Track top plastic finishing extrusion Fig. Page Fit The Powered Folding Rail Minivator series Installation Manual Fit the powered folding rail Splice the hinge rail section to the main track Locate as many screws as are accessible as per the track assembly instructions, and fit the required number of feet, and then Locate the Page Changing The Seat Position Minivator series Installation Manual Changing the seat position Seat harness connector The seat can be mounted at the left or right side of the seat chassis.
Front cover Refer to Figures 51, 52, 53 cut away for Note: clarity The seat stem should be fitted to the upper side of the unit. Page 25 Minivator series Installation Manual Lay the seat on its back, with foam rubber to stop any movement, and to avoid damage. Remove the screws locating the bottom cover moulding and remove the moulding Fig. Remove the 2 screws retaining the bottom cover Fig. Remove circlips and withdraw the latching levers Fig.
Unbolt the spring reaction bracket Fig. Slide the latching bar out. Page 27 Minivator series Installation Manual 10 Replace the plate in the required position, and tighten the Allen screws to 20Nm.
Page 28 Minivator series Installation Manual 14 Fit the latching levers into their bearings and over the latching bar and replace the circlips Fig Ensure the latching mechanism operates freely. Page 29 Minivator series Installation Manual 17 Fit the cover moulding using the two plastic nuts Fig. Page Appendix 3 Electrical Diagram - Options. Page Appendix 5 Electrical Diagram - Options. Page 35 Minivator series Installation Manual Page 36 Minivator Ltd.
DY6 7FJ. Print page 1 Print document 36 pages. Rename the bookmark. Delete bookmark? Cancel Delete. Delete from my manuals? Sign In OR. Don't have an account? Sign up! Sometimes a stairlift repair can be resolved by removing a simple obstruction, verifying the main switch is turned on or resetting the lift. How to check the five most common stairlift problems and more. Troubleshooting basic stairlift problems. Acorn User manual for the model Acorn Acorn Superglide User manual for the original model Acorn Superglide.
Acorn Curved User manual for the model Acorn curved. Handicare User manual for new Handicare Handicare Curved User manual for the Handicare model curved. Handicare Xclusive User manual for Handicare Xclusive. Harmar Pinnacle Owners manual for the Harmar Pinnacle model.
0コメント